User manual JBSYSTEMS Z-300

[. . . ] Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Fazer for years to come. Please follow these operation and safety instructions to ensure a long and safe life for your Fazer. [. . . ] In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Pour Antari Fog Liquid into the liquid tank, being careful not to exceed the maximum fluid level. Use only ANTARI Fog Liquid or other dealer-recommended high-quality Fog fluid . When the container is full, place the cap back on the liquid tank and tighten. Your Fazer can only be operated by connecting the Z-6 remote control into the remote control slot in the back of the machine. Operation Plug the remote control cord into the slot marked remote control on the back of the Fazer machine. The red light on the remote control will turn on once the machine is plugged into a power outlet and the on/off switch is turned on. This period varies depending on conditions but should not take more than 10 minutes under any circumstances. The green light on the remote control will turn on once the machine is ready to produce haze. When the green light turns on, the machine may be operated using the remote control. Prior to the green light turning on the machine will not haze and the functions will not respond. When the fluid is not low the light on the back of the machine is green and will flash on and off continuously. When the Fazer does not have any liquid in the machine the PC board will shut off the pump so that the machine will not be damaged. Even with the low level sensor, the Z-300 Fazer machine can suffer damage when run without fluid. If the machine does not function after having been run without fluid please contact your Antari dealer for service. If you experience low output, mechanical noise or no output at all, unplug immediately. [. . . ] The Fazer can operate using only fog fluids or fluids recommended by your dealer that are designed to be used exclusively in the Antari Z-300 Fazer. Contamination includes adding fragrances, oils, dust, or any other foreign materials to the Fazer liquid supply. Always replace the caps on the fog liquid container and the Fazer's liquid tank immediately after filling. [. . . ]