User manual JBSYSTEMS AVM-3 V1.0

[. . . ] Ely No naked flame sources, such as lighted candles, should be placed on the appliance. Always unplug the unit when it is not used for a longer time or before you start servicing. [. . . ] Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. Do not use volatile liquids such as benzene or thinner which will damage the unit. Check if your VIBE-speaker is already prepared for use with the new AVM-amplifier modules: ONLY the Mk2-serie is adapted for use with the AVM-amplifiers!If you have an older cabinet, installation is quite complicated and should only be considered if you are a well skilled person for the job. If your VIBE-speaker cabinet is prepared for easy installation of the AVM-modules than please proceed with the installation as described below: A. Unplug the passive VIBE-cabinet from the amplifier and unscrew the screws that keep the metal connector plate in place. Keep the screws for later and remove the connector plate: on the back you will notice a special connector. To disconnect the special connector, press the connector lock and separate the two connectors. [. . . ] IMPORTANT: be aware that the power of the AVM-modules often exceeds the max. This means that you must be very careful and always start with the master level (8) or trimmer (9) almost closed, than increase the level step by step. [. . . ]