User manual JBSYSTEMS LIGHT Z 1200II

[. . . ] Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine. Congratulations on the purchase of your new ANTARI Z-Series II FOG MACHINE. Disconnect the appliance from the electric supply before refilling liquid, cleaning or performing maintenance on the machine. Always unplug your ANTARI Z-Series II Fog Machine before filling its tank. [. . . ] Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage If your ANTARI Z-1200II Fog Machine fails to work properly, discontinue use immediately. Liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to your ANTARI dealer for service. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. One unit of Z-1200II Fog Machine Power cord Z-8 multi-function remote control with attached cord User Manual Model Number Power Supply Power Consumption Output Volume Tank Capacity Fluid Consumption Weight Dimensions(mm) Remote Included Z-1200II AC100-120V, AC220-240V / 50HZ-60HZ 1250 W ca. Remote Control Operation Z-8: 10 meter wired multi-function remote control with 5-PIN plug for ANTARI Fog Machine model Z-1200II. The Interval knob adjusts the time between discharges when the timer function is engaged. The volume can be adjusted using the volume knob to control the amount of fog produced. The volume knob can be used to regulate the volume of the steady stream of fog produced. The green MANUAL button will produce a continuous blast at maximum volume while the button is held down. When released, the manual function stops and the machine will return to the previous setting; timer, continuous, or stationary. Therefore, if both buttons have been depressed the Z-1200II will fog continuously. When depressed and held down the Z-1200II will fog at maximum volume for as long as the button is held down, regardless of the machine's setting at the time. Before beginning your initial setup on ANTARI Z-1200II Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any other types of fluid can damage the unit resulting in spitting and serious clogging problem. Firmly attach the Z-8 remote control cable to the proper input on the back of the machine. [. . . ] Timer functions such as duration and interval can be programmed using the DMX controller or the DMX control software being used by lighting and effects operator. When storing run distilled water (not tap water) through the system as described in the cleaning regimen above. This will help avoid any particles condensing inside the pump or heater. With 6 being the minimum volume of fog produced and 249 approaching the maximum. [. . . ]