User manual JBSYSTEMS LIGHT X-TERM 1 V2.2

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] The dots flow to the right when the platter speed is lower than the selected (33, 45, 78. When the dots seem to be stationary, the platter is rotating at the exact speed. TARGET LIGHT: White led target light used to locate the exact place on your record when used in a dark place. STARTUP TIME: Used to adjust the time it takes to reach the proper platter speed. Startup time is minimal when the potentiometer is completely turned to the left. 2sec) Startup time is maximum when the potentiometer is completely turned to the right. BRAKE TIME: Used to adjust the time it takes to completely stop the platter. Break time is minimal when the potentiometer is completely turned to the left. 2sec) Break time is maximum when the potentiometer is completely turned to the right. REVERSE Button: Press this button to reverse the platter rotation, press this button again to end the reverse mode. When the slider is in its middle position, a led will turn on to indicate that the turntable is locked to the exact center speed. When the QUARTZ Button is pressed, the exact center speed is enforced, even when the slider is not in the middle. PHONO/LINE Output: Depending on the position of the phono/line switch, you can connect the turntable to any phono or line input, using the supplied cinch/cinch cable. (a "cinch connector" is often also called "RCA-connector") 13. POWER CORD Connector: Used to connect to the mains, using the supplied power cord. During installation, attach the stylus protector to guard the stylus tip from damage. attach wires as follows: White (L+) Left channel + Blue (L-) Left channel Red (R+) Right channel + Green (R-) Right channel 15. HEAD SHELL LOCKING NUT: Attach the head shell by inserting it into the front end of the tone arm and then turn the locking nut clockwise. [. . . ] Put a record on the platter and make sure the antiskate is set to zero. Take the tone arm and turn the counterweight until the tone arm is in perfect balance It floats horizontally above the record surface, see "OK" picture at the right. Now set the "stylus pressure ring" (front section of the counterweight with markings) to zero by turning the ring while you take care that the counterweight doesn't move. [. . . ]