User manual JBSYSTEMS LIGHT X-310

[. . . ] Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine. Disconnect the appliance from the electric supply before removing the cover. Prior to use take care to determine that the unit is installed at the rated voltage. If moisture, water, or fog liquid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. [. . . ] WARNING: Use of any fluid other than ANTARI fog fluid or modification or attempted to unauthorized repair of the X Fazer will immediately invalidate the warranty. Warm-up is complete when the display on control module shows " Ready to Fog. When the fluid is running low, the LED inside the tank chamber starts blinking for two minutes and then stop operation to protect the pump from running dry. For further information on operating your ANTARI X Fazer, see the section titled, "Control Module Operation" on page 4. Caution: "Visibility during operation is reduced" If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of inclination. If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, control module connection, and power from the wall. If fog does not come out after holding the control module button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the control module button, as this may damage the unit. Its LCD displays current operating parameters, which are automatically stored in non-volatile memory, allowing the machine to be powered down without losing function settings. Pressing the Function key will cycle through different options including Volume, Timer, Heat & Fan. Use Enter (Volume) Key to select each option and make changes as desired. Press ESC(Timer) key to exit current menu level and move to an upper(previous) level. The display shows the adjusted interval and the device counts the seconds down to "0". If you wish to deactivate the timer function, press the Timer key once more. The address can be set from 0 to 8, which means total 9 different units can be controlled separately or in any combination desired. Make sure the address setting on the X-30 matches the address setting on the transmitter. Whatever channel you select on the unit, the channel next to it will be selected automatically for fan volume control. Timer functions such as duration and interval can be programmed using the DMX controller or the DMX control software being used by lighting and effects operator. [. . . ] Please read and save these instructions Warrants to the original purchaser that the ANTARI X Fazer will be free from original defects in workmanship and material for a period of six months from the date of purchase. During the warranty period, machines will be repaired or replaced at the option of ANTARI or its designated dealer. The warranty does not extend to any parts of the ANTARI X Fazer that have been subject to misuse or accident. Neither does the warranty cover any ANTARI X Fazer that has been opened, modified or repaired other than by ANTARI or its designated dealer. [. . . ]