User manual JBSYSTEMS LIGHT SW-416 V 1.0

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To take full advantage of all possibilities, please read these operating instructions very carefully. This product meets the requirements of the current European and national guidelines. [. . . ] The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. This appliance must be earthed to in order comply with safety regulations. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Check the contents: Check that the carton contains the following items: User manual SW-416 Unit ( Two 19" brackets mounted ) Some important instructions: Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. Do not use volatile liquids such as benzene or thinner which will damage the unit. dMX Input: receives incoming DMX signal DMX Output: transmits the incoming DMX signal to another DMX fixture. Dip Switches: These switches are used to assign a DMX address to the unit. Power Output: It is used to connect four different fixtures, such as lighting effects. 19 Inch Brackets: you can mount the SW-416 in different ways: Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the device in a well ventilated spot, far away from any flammable materials and/or liquids. [. . . ] Each channel can be used for the ON/OFF control of different equipment, such as lightings effects. The device will be switched ON when the DMX value is above 130, and OFF when the DMX value under 120. The Channel LEDs show the state of each channel on the front and the back panel. You have to set DMX address so that the unit can receive a DMX signal from the DMX controller. [. . . ]