User manual JBSYSTEMS LIGHT STORMBIRD V1.0

[. . . ] ⷠKeep this booklet in a safe place for future consultation. ⷠMake sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. ⷠAllow the device about 10 minutes to cool down before replacing the bulb or start servicing. ⷠAlways unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. [. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. ⷠDon't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the mains power. ⷠLocate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. ⷠDon't cover any ventilation openings as this may result in overheating. ⷠPrevent use in dusty environments and clean the unit regularly. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Use the small knob on top of the effect to adjust the focus of the gobos: · Loosen the knob a little until you can move it forward and backward. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands!If you touched the lamp, clean it with a cloth and a little denatured alcohol. ⷠRegular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. ⷠDo not switch the unit on and off in short time intervals as this reduces the lamp life. ⷠAlways unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. ⷠIn the event of serious operating problems, stop using the fixture and contact your dealer immediately. ⷠImportant: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. [. . . ] ⷠWhen an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. ⷠThe mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. ⷠIn order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. ⷠThe interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]