User manual JBSYSTEMS LIGHT SPACE LASER 3 V 1.0

[. . . ] Absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: SPACE 3 Laser unit 2 keys (for key switch) Mains cable Operating instructions Temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] CONTROL PANEL: Used to control the different functions of the laser, see further to learn how to operate the unit. REMOTE CONTROLLER INPUT: Input for the CA-8 remote hand controller, see further for more information on this issue. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. We suggest to take off the plastic cover from time to time to clean the dust filter inside. Don't operate the unit without the dust filter installed: dust will enter the enclosure and disturb the operation of the laser. SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure; make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. Use the keys to make sure only a skilled operator is able to switch the laser on. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. [. . . ] MODE button: used to toggle different modes: MODE LED OFF: Laser in full automatic mode. 5) DMX512 MODE: The laser can be controlled by any standard DMX-controller. Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the DMX-output of your controller. Press the FUNC-button until the display shows a 3 digit number Select the desired DMX-address (from 001 to 505) Press the ENTER-button to confirm your choice. [. . . ]