User manual JBSYSTEMS LIGHT SPACE COLOR V 1.2

[. . . ] Allow the device about 10 minutes to cool down before replacing the bulb or start servicing. Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. [. . . ] Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!INTERLOCK input: used to connect the optional emergency stop switch (see picture). For your own safety we strongly recommend to connect this optional switch!INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. DMX OUTPUT: 3pin female XLR-connector used to connect the Space Color laser with the next unit in the DMX chain. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and 255. Switch 9 is not used and switch 10 is used to select stand-alone or DMX mode. AUTO/MUSIC SWITCH: when the unit is used in stand-alone mode, this switch sets the laser in music mode (patterns move to the rhythm of the beat) or auto mode (patterns move automatically) 10. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 11. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. Use the keys to make sure only a skilled operator is able to switch the laser on. SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. Don't use the effect in the presence of persons suffering from epilepsy. Good to know: Every time you turn the unit on, it moves the motors to their `home' position so you may hear some noises for several seconds. After that the unit will be ready to receive DMX signal or run the built-in programs. [. . . ] CAUTION EYEDAMAGE: Always position the laser in a way that prevents the audience from looking directly into the laser beams. The installation should assure that the beam will not strike the audience. Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. Do not switch the unit on and off in short time intervals as this reduces the lamp life. [. . . ]