User manual JBSYSTEMS LIGHT SMP 8.2 V1.0

[. . . ] Other fog liquids may cause Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage If your ANTARI Z-800II, Z-1000II and SMP 8. 2 Fog Machine fails to work properly, discontinue use Congratulations on the purchase of your new ANTARI Z-Series II FOG MACHINE. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Fog Machine for years to come. [. . . ] By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ANTARI Fog Machine for years to come. Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine. Drain all fog liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to your ANTARI dealer for service. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. Disconnect the appliance from the electric supply before refilling liquid, cleaning or performing maintenance on the machine. Before beginning your initial setup on ANTARI Z-800II, Z-1000II or SMP 8. 2 Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Always unplug your ANTARI Z-Series II Fog Machine before filling its tank. If moisture, water, or fog fluid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. All fog machines have a recycling period after long bursts when the machine will shut itself down for a short period in order to heat up again. Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is recommended to run a cleaning solution composed of 80% distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in the heating element. Run the machine briefly to clear any cleaning solution from the pump and heater. Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and the high temperature at which it vaporizes. However, a properly maintained fog machine should provide years of reliable use. When storing run distilled water (not tap water) through the system as described in the cleaning regimen above. This will help avoid any particles condensing inside the pump or heater. When the fog machine has reached operating temperature the green lamp on this remote control will light up, indicating that the operator may begin fog emission by pressing the red button. Its two knobs allow the operator to customize fog machine functions by adjusting output duration and interval. [. . . ] When the fog machine has reached operating temperature the green lamp on this remote control will light up, indicating that the operator may begin fog emission by pressing the red button. Its two knobs allow the operator to customize fog machine functions by adjusting output duration and interval. Adjust the interval between each fog emission (within the range of 10 seconds to 5 minutes) by means of the INTERVAL control knob. Adjust the duration of each fog emission (within the range of 1 to 10 seconds) by means of the DURATION control knob. [. . . ]