User manual JBSYSTEMS LIGHT PSX-12A V1.0

[. . . ] The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. ⷠTo prevent fire or shock hazard, do not expose this appliance to rain or moisture. ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] ⷠThis appliance must be earthed to in order comply with safety regulations. This appliance meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. Light weight heavy duty Polypropylene cabinet Built-in power amplifier Treble/bass tone controls + master volume. Balanced / unbalanced microphone input (jack + XLR) with volume control Balanced / unbalanced line input/output (XLR) with volume control. IEC input/output mains connectors Perfect for permanent installations Perfect for Portable use High power Woofer High power Compression Driver & Horn Built-in Rigging points Built-in 35mm stand adapter Monitor stand adapters included Built-in heavy duty carrying handle Heavy duty rubber feet. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. ⷠImportant: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. ⷠKeep this booklet in a safe place for future consultation. ⷠTo protect the environment, please try to recycle the packing material as much as possible. Always replace a damaged fuse with a fuse of the same type and electrical specifications! ⷠIn the event of serious operating problems, stop using the appliance and contact your dealer immediately. ⷠPlease use the original packing when the device is to be transported. ⷠDue to safety reasons it is prohibited to make unauthorized modifications to the unit. For the line level in/outputs you can use readymade XLR-cables such as our JB SYSTEMS codes 7-0063 (5m) or 7-0067 (10m). For the speaker output: you can use readymade cables such as our JB SYSTEMS codes 2-0505 (5m). You will also need a pair of Neutrik Speakon® NL4FC connectors. [. . . ] REMARK: while the cabinet is in use, you will see a blue LED blinking on the front side of the PSX-12A. This makes it possible to check from a distance if the cabinet amplifier is switched on and receives an audio signal. For this purpose you can use heavy duty eyebolts with metric M8 thread. In most cases 2 cables will be attached to the top and one is used to pull up the back. [. . . ]