User manual JBSYSTEMS LIGHT PMD 8

[. . . ] Therefore, this manual shows the control functions of only one channel. LINE INPUT Use with 1/4" standard line connector, you can use unbalanced (tip/sleeve) and balanced (tip/ring/sleeve). PAD (-20dB) When you push this switch it attenuates the input signal with ­20dB. [. . . ] Turn off the other channels to improve the sound and to clear any unnecessary noise. PRE-FADER LEVEL (PFL) You can control the signal of one channel by turning on the PFL switch. When the PFL switch is on, other channels are automatically cut off (see monitor section). INDICATION You can put a sticker on which you can write the input signal. UNBALANCED OUTPUT JACK CONNECTORS Tip = signal + Ring = ground Sleeve = ground (shield) 3. MASTER LEVEL DISPLAY It shows the output levels of the left and the right. LEFT MASTER FADER By adjusting the slider you control the mixed left output. DSP DIGITAL INDICATOR Indicating the effect which the dsp is working at. When you choose different presets, the correspondent number will change accordingly. When you push the presets, the led is on but there is nog effect output. Only when you push the enter key (13), there is correspondent effect output and the led will stop flashing. DSP ENTER When you choose your presets, please push the key and than the dsp is at the effect status that you choose. AUX INPUT Used with 1/4" stereo jack, you can connect it with stereo equipment or other external signal. AUX OUTPUT Connect this jack with the input jack of a monitor amplifier. [. . . ] LEFT MASTER LEVEL CONTROL You can control the aux return level by adjusting the switch. RIGHT MASTER LEVEL CONTROL You can control the aux return level by adjusting the switch. PFL SWITCH If you push this switch, you can monitor the effect only in your headphones. [. . . ]