User manual JBSYSTEMS LIGHT PLANO SPOT LED V 1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. [. . . ] Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Insert the mains cable. The unit starts working immediately in the last selected stand-alone mode. Refer to chapter HOW TO SETUP to learn how to switch between static and sound mode. Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables. The unit that has no cable connected to its DMX-input is the "master", the others are the slave units. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. MAIN MENU: To select any of the menu options, press the MENU button up to when the required option is shown on the display. once the required menu option is selected , press the ENTER button to select. [. . . ] Connect an optional LEDCON-02 controller for more control: The LEDCON-02 controller can only be used in standalone or master/slave mode. Make sure that the PLANO SPOT projectors are all set to channel mode1 (Md 1). Mains Input: Power consumption: Fuse: IEC input/output daisy chaining: Sound Control: DMX connections: LEDs: Beam angle: Luminous intensity: Size: Weight: 230V 50Hz 28Watt 250V 6, 3A slow blow (20mm glass) 50pcs Internal microphone XLR 3pin 212 high power LEDs (R70 + G71 + B71) 15° see chart below see drawing below 1, 6kg Refer to the chapter "Electrical installation for two or more units in DMXmode" to learn how to do this (don't forget to address all units properly!Since each unit has its own DMX-address, you can control them individually. [. . . ]