User manual JBSYSTEMS LIGHT MX4 MK2 V1.1

[. . . ] The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Beat leds help you to find the right cadence · To prevent fire or shock hazard, do not expose this appliance to rain or moisture. Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. [. . . ] The crossfader only works when you move the selected channel faders (7) to the desired level!FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. The audio risks to be distorted when the signal level comes in the red zone of the VU-meter. PFL VU METERS: Monitors the level of the channel you selected with the PFL-switch (6). CUE MIX: With this fader you can mix the master output and any of the input channels through the headphone output (16): · Put the fader in the extreme left position to monitor a selected PFL signal (6). Put the fader in the extreme right position to hear the master output. Put the fader in any other position to hear a mix of the two signals. This option makes it possible to check your mix before you put it on the master output. HEADPHONE jack: You can monitor all inputs/outputs when you connect any modern stereo headphone to this 6. BALANCE MASTER1: used to adjust the balance between left and right output on Master1. INPUT SOURCE SELECTOR: Used to select the correct input on each channel: Phono, line, aux or mic. 3-BAND TONE CONTROLS: The frequency of each channel can be controlled separately over a range from -26dB to +12dB. TALKOVER: Use this switch to automatically mute the input channels 2 to 4 while you are talking through the DJ microphone. Pressing multiple Cue-buttons makes it possible to derive a mixed sound from the selected sources. These fader starts are compatible with all current JB Systems CD-players. CROSSFADER IN LEFT POSITION: CD-player connected to fader start connector 1 is playing, the other CD-player is paused. CROSSFADER MOVES TO THE RIGHT: CD-player connected to fader start connector 1 stops playing, returns to its previously programmed cue point and waits in pause. The other CD-player starts playing from its previously programmed cue point. [. . . ] LINE INPUT CHANNEL1: used to connect a line level audio signal to channel1. PHONO/CD SWITCH: This switch makes it possible to switch between the CD and phono level inputs on channels 2, 3 and 4. RECORD OUTPUT: porte le même signal que les sorties master, mais n'est influencé, ni par le niveau du master, ni par le réglage de la balance, ni par le sélecteur mono/stéréo. [. . . ]