User manual JBSYSTEMS LIGHT MSD 900 V1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities, please read these operating instructions very carefully. This appliance meets the requirements of the current European and national guidelines. [. . . ] This control works differently depending on the cue system you selected in the setup menu (see chapter SETUP MENU for more information): CUE SYSTEM = BPM/TAP: Turn the CUE PAN knob to the left side to hear the cue signal from the left player. If you turn it to the right, you will hear the cue signal of the right player. CUE SYSTEM = CUE on/off: Turn the CUE PAN knob to the left side to hear the cue signals from both players. You can turn the cue signal from each player on/off using the BPM/CUE If you turn it to the right, you will hear the mixed output signal. Note that, due to the high output power, you can permanently damage your ears!PITCH DISPLAY: Shows the actual percentage of speed change, selected with the SPEED slider. The small padlock is shown when the pitch lock function (Master Tempo) is active. (see chapter SETUP MENU for more information) Note: for MP3 files it's not possible to show the total remaining time for all tracks on the memory device. SINGLE: appears when the unit is set to play just one track at a time. When it is not shown, the player plays continuously through all tracks. AUDIO OUTPUT from right player: Output for the audio signal from the right player. Use the supplied cinch/cinch cables to connect these outputs to the CD/line input of an external mixing unit. AUDIO OUTPUT from left player or mixer: Output depends on the MIXER MODE you selected in the setup menu (see chapter SETUP MENU for more information): MIXER MODE = Ext -Tone: output for the audio signal from the left player. Use the supplied cinch/cinch cables to connect these outputs to the CD/line input of an external mixing unit. MIXER MODE = Ext +Tone: same as "Ext ­Tone" but now the tone controls can be used. Use the supplied cinch/cinch cables to connect this output to the input of an amplifier or powered speaker cabinets. FADER START Sockets: If you are using a mixer with fader start function, connect the player with the fader start of the mixer. Please note that these sockets must never be connected with any voltage. Attention: This remote control is only compatible with certain (Synq® or Pioneer® compatible) mixers. In the setup menu you can adapt several parameters of the MSD900 to your personal taste. to access the setup menu , just press the SEARCH button (3) for about 1. 5sec: he display shows "SETUP MENU" while the red SEARCH button (serves as NO-button) and green BPM/CUE button (serves as YES-button) are both lit. [. . . ] Power Supply: Frequency response: THD + noise: S/N Ratio (IHF-A): Player outputs: Mixer output: Tone controls: Headphone: MP3 FORMATS: MPEG1 Layer3 (ISO/IEC11172-3): Bitrates: Bitrate modes: MPEG2 Layer3 (ISO/IEC13818-3): Bitrates: Bitrate modes: MPEG2, 5 Layer3: Bitrates: Bitrate modes: Possible file extensions: Maximum MP3-file size: ID3 tag compatibility: Dimensions: Weight: DC 6V / 1, 5A ~ Special AC/DC adapter should be used!STORING A MASTER CUE POINT: There are 2 ways to set a master cue point: Press the IN button (19) during normal playback to set the new cue point ("CUE on the fly"). Put the player in pause and use the jog wheel to search for the exact location for the cue point. Once this location is found, press "IN" button to set the new cue point. [. . . ]