User manual JBSYSTEMS LIGHT MLS-50 V 1.0

[. . . ] No visible connection cables, they are completely hidden inside the units Available in 2 lengths: 20cm and 50cm To be used with our LED-MANAGER (DMX power supply) Long life LED Technology!Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. The cables should always be in perfect condition: switch the LED Manager immediately off when the cables are squashed or damaged. [. . . ] To protect the environment, please try to recycle the packing material as much as possible. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. If a foreign object enters the unit, immediately disconnect the installation setup from the mains power. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during installation and servicing. Before installation make sure that the installation area can hold a minimum point load of 10times the device's weight. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Mounting with Two-side adhesive tape: This is the easiest and fastest way but only possible on a smooth surface!Put it on the bottom or side of the U-shaped enclosure as shown on the drawings. Mounting with smallscrews: This takes a little more time but the mounting surface doesn't have to be so smooth, you can even fix the LED strip on a surface covered with carpet. remove the PCB from the U-shaped plastic rail just by sliding it to one side. Important: do NOT touch the electrical contacts on the bottom of the PCB, electrostatic discharges can destroy the LEDs!(see picture) Fix the plastic rail on the surface using adapted small screws. Slide the PCB back in place (don't forget to first put the supplied small connection cable to the output connector on the bottom) This chain can be connected to one of the LED Manager outputs since it does not exceed the allowed 150W. Since the MINI LED STRIPS are controlled by the LED Manager, we strongly advice to read the operation instructions in the LED Manager user manual. [. . . ] The cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. The cleaning of the plastic enclosure must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. After installing the units just daisy chain the in/output cables of all LED STRIP units up to the maximum allowed load. [. . . ]