User manual JBSYSTEMS LIGHT MIX 5.2 V1.0

[. . . ] No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. minimum distances around the apparatus for sufficient ventilation is 5cm. Always unplug the unit when it is not used for a longer time or before you start servicing. [. . . ] Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. When the power switch is in OFF position, this unit is not completely disconnected from the mains!Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. LINE INPUTS: Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, Hi-fi VCR's, cassette and reel-to-reel tape decks, DAT machines, tuners, even synthesizers or other mixing consoles. RECORD OUTPUT: Carries the same signal as the master outputs but is not influenced by the master level control. HIGH AND LOW EQ: Adjusts the high and low frequency levels of the input channels for a good sound. iNPUT FADER: Controls individual source levels (channels) in the mix. REPLACEABLE CROSSFADER: Achieves clean segues between the two input channels. Simply unscrew the two large screws which hold it in place, lift it out and disconnect the cable. Re-attach the new crossfader and screw the mounting plate back on the unit. INPUT TOGGLE SWITCH: Selects which source will be active based on what you have connected to the rear panel input section. FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. These fader starts are compatible with all current JB Systems CD-players. [. . . ] FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. These fader starts are compatible with all current JB Systems CD-players. CROSSFADER IN LEFT POSITION: CD-player connected to fader start connector A is playing, the other CD-player is paused. CROSSFADER MOVES TO THE RIGHT: CD-player connected to fader start connector A stops playing, returns to its previously programmed cue point and waits in pause. [. . . ]