User manual JBSYSTEMS LIGHT MIX 3 USB V1.0

[. . . ] To protect the environment, please try to recycle the packing material as much as possible. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. [. . . ] INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE MIXER: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. this symbol means: Safety Class II appliance This symbol means: Read instructions. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. Except for microphone and headphone outputs, all connections are cinch. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. Both USB connections will be detected as a sound card on your computer. These connections are bidirectional (play/record music simultaneously) CHANNEL FADER: Used to set the level of each channel separately. INPUT SOURCE SELECTOR: Used to select the correct input on each channel: Phono, line or USB. 3-BAND TONE CONTROLS: The frequency of each channel can be controlled separately over a range from -26dB to +12dB. (switched off) CROSSFADER: With this fader you can mix over between the channels 1 & 3. The crossfader only works when you move the channel faders (6) to the desired level! [. . . ] The Phono/CD selector (24) on the back makes it possible to switch between the Line and Phono level for these inputs. If your turntable does not have a ground wire, you don't have to use this connector. PHONO/CD SWITCH: This switch makes it possible to switch between the Line and Phono level for these inputs This is what you must do to change the cross fader: Remove the fader knob from the cross fader. Unplug the cross fader from the cable (unplug the cable by pulling the connector, NOT the cable! [. . . ]