User manual JBSYSTEMS LIGHT MINI WAVE V 1.0

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. ⷠKeep this booklet in a safe place for future consultation. Don't cover any ventilation openings as this may result in overheating. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] ⷠTo prevent fire or shock hazard, do not expose this appliance to rain or moisture. ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. ⷠDon't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the mains power. ⷠLocate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. Optical lens with manual focus adjustment Hanging bracket with 1 to fasten the unit and a mounting hole (M8) to fix a mounting hook like CR16/30. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. Don't touch the bulb inside the reflector of the lamp with bare hands!If you touched the lamp, clean it with a cloth and a little denatured alcohol. ⷠThe 3-mode switch (9) can be used to control the scan mirror of the unit: o Switch set to "0": no rotation o Switch set to "1": continuous rotation o Switch set to "2": sound activated rotation · Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. ⷠDo not switch the unit on and off in short time intervals as this reduces the lamp life. ⷠAlways unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. ⷠIn the event of serious operating problems, stop using the fixture and contact your dealer immediately. ⷠImportant: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. Important: The installation must be carried out by qualified service personal only. [. . . ] ⷠWhen an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. ⷠThe mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. ⷠIn order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. ⷠThe interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]