User manual JBSYSTEMS LIGHT LEDCON-02 V 1.1

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. [. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. Do not use volatile liquids such as benzene or thinner which will damage the unit. If you should use another adapter, please make sure that it has 9Vdc and minimum 300mA with + in the center. CHASER CHANNEL MODE: used to determine if the LEDCON-02 should work as a 4 or 8 channel LED light modulator. Please note that you should always run the "auto address" function after changing the channel mode!COLOR / CHASE BUTTONS: These buttons have different functions, depending on the selected working mode (refer to n°2): FIXED COLOR MODE: You can select 9 different predefined colors. (sound activated or not) AUTO ADDRESS MODE: You can determine the order of succession of the connected LED PARprojectors. MODE SELECT BUTTONS: 3 buttons used to set the controller in different working modes: FIXED COLORS: select this mode if you want to use the "fixed color" buttons (1). CHASE MODE: used to select two different chase modes: CHASE 1: select this mode if you want to select one of the 12 color chases using the "chase/color" fader (3). CHASE 2: select this mode if you want to use the controller as a 4 or 8 channel DJ light modulator. You can use the "color / chase buttons" (see n°1) to select the different chases. SPECTRUM MIX: select this mode if you want to select one of the 32 different colors using the "chase/color" fader (3). CHASE/COLOR FADER: used to select one of the available color chases: Left side of the fader indicates the different chases. Important remark: There's also a function called "color fade" which is very nice for "background lighting" applications. SPEED/FADE FADER: used to select the chase speed or color fade time: Left side of the fader indicates the chase speed, ranging from 2, 5s to 0, 1s. SOUND BUTTON: used to toggle the chase mode between sound and static mode. Press this button during the "auto address" mode to select the previous projector. Press this button during the "auto address" mode to select the next projector. Press this button for about 5seconds to start the "automatic address" function. With LED MANAGER and/or MINI LED MANAGER: Just "daisy chain" the DMX in/outputs of 1 or more LED-Managers with the DMX-output of the LEDCON-02 remote using a good quality balanced cable. [. . . ] The address distribution depends on the channel mode and the number of connected LED projectors. Some examples: Set to 4 channel mode with 20 projectors addressing will be: 1234 ­ 1234 ­ 1234 ­ 1234 - 1234 Set to 8 channel mode with 20 projectors addressing will be: 12345678 ­ 12345678 - 1234 A. First determine if you will put the LEDCON-02 in 4 or 8 channel mode (see switch n°12) B. Press the "blackout" button (see n°8) for about 5seconds: until the red "blackout LED" starts blinking. [. . . ]