User manual JBSYSTEMS LIGHT LED WALL DIMMER V 1.0

[. . . ] The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. In the event of serious operating problems, stop using the appliance and contact your dealer immediately. [. . . ] Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To protect the environment, please try to recycle the packing material as much as possible. This symbol means: indoor use only This symbol means: Read instructions To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. ANY OTHER JB SYSTEMS LED PRODUCT: ® You can also use it together with other JB Systems LED products like LED Ball, LED Par, LED SPOT/WASH, LED MANAGER 300W, . However in these cases you will need a separate +12Vdc power supply connected to the Wall Dimmer. the DMX outputs will be connected via a good quality balanced DMX- cable and XLR-connector. MECHANICAL INSTALLATION IN WALL BOX: The LED Wall Dimmer can be installed in any standard recessed wall box with screw fixations: Take the cover plate off (easy click-on system) Locate the unit in the recessed wall box and fasten with the 2 screws. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. FADE/COLOR KNOB: has different functions, depending on the working mode (see n°5): RGB1 & RGB2 MODE: o Used the select one of the many preprogrammed colors. [. . . ] O RGB1 MODE: this is the standard working mode, nothing special should be done. COVER PLATE: two interchangeable cover plates for the different working modes can be easily clicked on the wall dimmer. WIRE TERMINALS: easy press-on wire terminals, see chapter "installation" for more information. [. . . ]