User manual JBSYSTEMS LIGHT LED STRING RGB

[. . . ] It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. [. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. Mains connector: check if the mains voltage is not higher than 230V / 50Hz 2. Rubber seal: used to seal the program selector (5) completely from any possible moisture. Program selector: used to select one of the 16 internal programs, see chapter how to use for more information. RGB LED-bulbs: contains multicolor LEDs, you can add up to 200pcs in one line (string)!String connectors: special IP44-rated connectors, not available on the string of this RGB-starter set. Fixing eye: can be used to clamp or stretch the string from the ceiling down etc. NEVER disconnect any parts or make any change in the setup while the installation is connected to the mains: some parts could be severely damaged!THE SIMPLE WAY If you only want to use the standard "plug & play" starter set, things are VERY simple: just build the elements from this "LS-RGB-STARTER" starter kit together and connect the complete string to the mains. THE SOPHISTICATED WAY Based on the basic "LS-RGB-STARTER" set you can build a bigger system, just by adding the optionally available accessories. For each of these accessories we give a description with possible applications: LS-POWER-7A The controller of the "starter set" can control strings with up to 200 LEDbulbs, however its internal power supply only supports up to 12 LED-bulbs. This means that you should add an extra power supply, as soon as you add extra strings. The LS-POWER-7A power supply can deliver power for up to 116 LED-bulbs. So every 116 LED-bulbs an extra LS-POWER-7A should be inserted in the line. The LS-POWER-7A contains a special POWER-T, used to "inject" the extra power into the line with strings. See the example below to learn how to insert the LS-POWER-7A: You can add one or more strings in one line until a maximum of 200 LED-bulbs is reached. Of course you should add extra LS-POWER-7A power supplies and LS-BUFFER signal buffers where needed! LS-CURTAIN-2M An LS-CURTAIN-2M is a 2m long cable containing 8 T-connectors, used to create a nice LED-curtain. Theoretically you can connect up to 50 LS-RGB-STRING cables (200 LED-bulbs) to each of these 8 T-connectors. Of course you should add extra LS-POWER-7A power supplies and LS-BUFFER signal buffers where needed!The picture on the right gives you an idea of such a "curtain application". LS-EXTENSION-3M This 3m long cable is used for bridging the distance between two elements in a setup. [. . . ] In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Important: Don't use the effect in the presence of persons suffering from epilepsy. Buffers should be used in the following cases: When one or more LS-EXTENSION-3M cables are used, you should add a buffer before the extension cable(s). Never connect 2 buffers to each other, there should always be at least one LS-RGB-STRING between 2 buffers. [. . . ]