User manual JBSYSTEMS LIGHT LED SNOW FLAKES V 1.0

[. . . ] This product meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. This device was designed to produce decorative effect lighting and is used in light show systems. [. . . ] Standard flammable surfaces include building materials such as wood and wood-based materials more than 2mm thick. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. If a foreign object enters the unit, immediately disconnect the mains power. Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. Check that the available voltage is not higher than the one stated on the rear panel of the unit. Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. AC-CONNECTOR: special IP44 connector, connect the wire of with icicles here. Make sure that the clamping ring of the connector is well tightened before you start using the effect. [. . . ] In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Important: Don't use the effect in the presence of persons suffering from epilepsy. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. [. . . ]