User manual JBSYSTEMS LIGHT LED ROPE V 1.1

[. . . ] This can be done by simply connecting the conductors of the power cable with the colored conductors of the cables delivered with the LED MANAGER. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. This product meets the requirements of the current European and national guidelines. [. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Operating instructions 30m Led rope light MIDDLECONNECTOR: Used to link 2 pieces of LED RGB rope light together. This LED RGB rope light can only be used together with the JB SYSTEMS® LED MANAGER !Don't use lengths over 30m, the internal conductors will be overloaded which will damage the rope light!( more info below ) With all LEDs switched on, this rope light consumes about 2 Watts/meter. This means you can connect up to 150m on 1 LED MANAGER (75m on each output: 2x 75m = 150m) The rope light can be cut every 50cm (cutting marks available) This product can be used in indoor and outdoor situations, the maximum ambient temperature is 45°C. You can install the rope light easily on any surface, we suggest using the optional mounting tracks. When you have to install lengths over 30m, just split up the installation in several individual lengths. With a sharp cutting device (very sharp hobby knife or wire cutter) you can easily cut the rope light on the cutting marks ( scissor symbol every 50cm) to split it up in several parts. The power cable comes together with a rope light connector that must be installed on the rope light first. Attention: the holes and pins are a little out of the center, make sure to insert the pins in the right way and push the connector from the power cable as far as possible on the rope light!Strip the other end of the power cable and connect it to one of the two small cable assemblies that came with the led manager. To make it waterproof you must put some silicon on the inside of the cap before you press it on the rope light. Use a small hacksaw to cut the mounting tracks to the desired lengths. When all tracks are in place you just have to press the rope light in the mounting tracks. [. . . ] The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. Supplyvoltage: Powerconsumption: Cutting marks: Soundcontrol: Diameter rope light: Size: Weight: 3x 24V common anode 2 Watt/meter every 50 cm none, see Led Manager 14 mm 30 m 192 g/meter Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Belangrijke opmerking: De led rope werkt ENKEL in samenwerking met een apart toestel, de LED MANAGER (controle van de leds via DMX), waaraan deze led rope light dient aangesloten te worden. [. . . ]