User manual JBSYSTEMS LIGHT LED PIPE RGB 230V V 1.0

[. . . ] If a foreign object enters the unit, immediately disconnect the mains power. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Always unplug the unit when it is not used for a longer time or before servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. [. . . ] Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED PIPE RGB unit CAUTION: To reduce the risk of electric shock, do not remove the top cover. LED PIPE SIGNAL INPUT: low voltage signal input to be connected with the signal output of the previous tube or with the signal output cable from the controller. LED PIPE SIGNAL OUTPUT: low voltage signal output to be connected with the signal input of the next tube. POWER INPUT CABLE: To be connected with power output cable of the previous tube or directly with the mains. POWER OUTPUT CABLE: To be connected with the power input cable of the next tube. The shape of the enclosure and the holders makes it possible to hide your cables perfectly behind your construction. PLASTIC COVER: The milky white plastic cover is used to mix the 3 primary colors. If you like you can install the LED PIPE tubes behind a big milky white opaque surface to create an "ever color changing wall". In this case you can try to remove the plastic cover from the LED PIPE to obtain more light output. This can be easily done by removing the 2 small screws on one side of the plastic cover. Once the end cap removed you can easily slide the plastic cover out of the base. For detailed explanations on how the controller works and how you can control your setup by DMX, please refer to the user manual for the LED PIPE controller. INSTALLATION WITHOUT CONTROLLER: The installation without controller is almost identical so please refer to points 1 to 3 above. When no controller is connected, the first unit in the chain will act as the master: only use the DIP-switches on this master unit. the DIP-switch settings on the other (slave) LED PIPES have no effect. PATTERN REPETITION Dipswitch 1+2: used to choose after how many tubes the build-in patterns are repeated. PATTERN PLAYBACK SPEED Dipswitch 5+6: used to set the playback speed of the patterns in auto mode Playback speed is very slow. [. . . ] Make sure the area below the installation is free from unwanted persons during servicing. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. [. . . ]