User manual JBSYSTEMS LIGHT LED PIPE CONTROLLER V 1.2

[. . . ] Dedicated controller used to control the RGB LED PIPE 230V led tubes (not included) Controls up to 1000 tubes, no extra power boosters needed. 32 preprogrammed patterns in 4 modes o Auto mode: 8 internal automatic patterns o Sound mode:8 internal music activated patterns o dB mode: 8 internal music activated "VU meter-like" patterns o Hold mode: 8 built-in full color patterns Pattern selection by DMX512: o Channel1: choose working mode o Channel2: choose pattern according to the selected working mode o Channel3: speed + direction Nice metal enclosure Auto save function: saves the last working mode for all patterns individually. Always unplug the unit when it is not used for a longer time or before you start servicing. [. . . ] MENU BUTTON: used to navigate between the main working modes (system set, auto mode, sound mode, dB mode, hold mode, reset mode and Standby mode) or to go back to a higher level in the menu structure. UP BUTTON: used to choose a higher value for the selected parameter or to navigate in the menu structure. DOWN BUTTON: used to choose a lower value for the selected parameter or to navigate in the menu structure. DMX INPUT: The RGB LED PIPE controller only receives DMX signals so it must be connected as any other light effect in the DMX line. DMX OUTPUT: The 3pin female XLR-connector is used to connect the controller with the next unit in the DMX chain. Extra signal cable extensions are optionally available in different lengths. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. To be sure that the LED PIPE system works properly you must follow the steps below every time you change the number of tubes, put tubes at different locations or simply disconnect and reconnect one or more tubes: INSTALL ALL TUBES: Refer to the installation manual included with each LED PIPE RGB 230V for proper installation. [. . . ] O dB mode: 8 music activated "VU meter-like" patterns o When a pattern is selected you still have to select the desired speed (speed is blinking). O You also have to choose in which direction the pattern should run (current direction is flashing) choose "left" or "right" and confirm with ENTER. O Hold mode: 8 built-in full color patterns o Just choose the desired color and confirm with ENTER. [. . . ]