User manual JBSYSTEMS LIGHT LED OCTO PANEL V 1.1

[. . . ] 27 Channel mode: all 8 panels are programmed individually, including 3 extra effect channels Can be easily mounted against walls and ceilings: all controls and connections situated on the back panel for seamless integration in design interiors Can be mounted in stage truss with the included brackets. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions To protect the environment, please try to recycle the packing material as much as possible. [. . . ] (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. DMX channel setup mode Used to set how many DMX channels the unit may occupy: 6 Channel mode: all 8 panels are programmed together 9 Channel mode: 2x 4 panels are programmed together 15 Channel mode: 4x 2 panels are programmed together 24 Channel mode: all 8 panels are programmed individually for maximum flexibility!27 Channel mode: all 8 panels are programmed individually, including 3 extra effect channels This is how to select the right DMX-channel mode: Press the MENU button until is shown on the display. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Once the correct channel mode shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Once the desired show is shown on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) Once the desired show is selected, you will be asked to choose the playback speed: display blinks while showing . use DOWN and UP buttons to select the desired speed: SP01 (slow) to SP08 (fast). No need to confirm, just use the MENU button to go back to the main menu. [. . . ] When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]