User manual JBSYSTEMS LIGHT LED FLOWER DMX V2.00

[. . . ] To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. If a foreign object enters the unit, immediately disconnect the mains power. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED BALL unit Chain M6 eyebolt Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In that case you still have to set the DMX-addresses of these DMX-effects manually!Standalone 1unit: Just connect the unit to the mains and put on some music. Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. Two or more units in master/slave setup: Connect 2 to maximum 16 units together. Refer to the chapter "electrical installation" to learn how to do this (don't forget to address all units properly!The units will start working automatically to the rhythm of the music and show the internal chase programs. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. Connect the optional CA-8 controller for more control: The CA-8 controller can only be used in standalone or master/slave mode. Now you can control all the connected units: IMPORTANT REMARK: When you use this LED PROJECTOR with a CA-8 controller and you select MANUAL mode (mode LED = ON), the projector reminds the last setting used with controller, even after disconnecting the controller and/or the mains voltage. If you don't want this, make sure to select another working mode (mode LED must blink or off) before you unplug the controller. Important: The installation must be carried out by qualified service personal only. [. . . ] The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. 3 different fixing methods are possible: Fixed to ceiling or truss (1m chain included) Wall fixing (optional wall adapter available) Pole mount (optional adapter for poles up to D=60mm available) Refer to the chapter "Electrical installation for two or more units in DMX-mode" to learn how to do this (don't forget to address all units properly!Since each unit has its own DMXaddress, you can control them individually. [. . . ]