User manual JBSYSTEMS LIGHT LED CROSSFIRE V1.0

[. . . ] To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. [. . . ] If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!This appliance must be earthed to in order comply with safety regulations. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. ALUMINIUM BODY: The aluminium enclosure is equipped with a sliding mechanism on both sides: BOTTOM SIDE: Use the 4 bolts/nuts (2) to attach the PAR projectors. uPPER SIDE: Can be used to attach 2 (optional) clamps for installation under truss. In this case you should also use the included lifting eye bolt to secure the LED 4Bar with a suitable safety cable (optional). 35mm STAND ADAPTER: used to put the LED 4Bar easily on top of a light stand 4. 4A DMX-INPUT: used to connect the LED 4Bar to the DMX-output of the previous unit in the DMXchain. 4B DMX-OUT TO PROJECTOR1: use a standard premade DMX-cable to connect connector 4B to the DMX-input of the first LED projector. STRAIN RELIEFS 5A + 5B: used to install any premade DMX-cable (see further to learn how to install this cable). STRAIN RELIEFS 6A + 6B: used to install any premade DMX-cable (see further to learn how to install this cable). STRAIN RELIEFS 7A + 7B: used to install any premade DMX-cable (see further to learn how to install this cable). 8B DMX-OUTPUT: used to connect the LED 4Bar to the DMX-input of the next unit in the DMX-chain. POWER INPUT: mains input, equipped with a Neutrik Powercon , make sure the local voltage is 230Vac and the projectors (and/or light effects) are properly connected to the channel output sockets (11) before you connect an earthed mains cable to this input. [. . . ] 8B DMX-OUTPUT: used to connect the LED 4Bar to the DMX-input of the next unit in the DMX-chain. POWER INPUT: mains input, equipped with a Neutrik Powercon , make sure the local voltage is 230Vac and the projectors (and/or light effects) are properly connected to the channel output sockets (11) before you connect an earthed mains cable to this input. When the fuse is blown, first locate and solve the problem that caused the fuse to blow. When the problem is solved, simply push the button to reset the circuit breaker. [. . . ]