User manual JBSYSTEMS LIGHT LED BALL OUTDOOR V 1.4

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. [. . . ] However we strongly suggest to use XLR & JACK cable connectors when the unit is used in mobile applications. ) Electrical installation for 1 standalone unit: Just install the mains cable (refer to point A) Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables (like for example JB Systems MC-01 cable). refer to sections "B" and "C" to learn how to connect the units together. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. Electrical installation for two or more units in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Gently unscrew the plastic dome from the plastic base and separate both parts. Place the plastic dome in a safe place so it won't be damaged during the installation. If the LED BALL is used with one of the optional adapters, make sure the base is mechanically well fixed before you start connecting the electrical wires. Especially when the unit is installed outdoors, you should use suitable cabling that withstands the weather conditions in your country (rain, sun, heat, cold, . ) On the base you will see 3 cable entry glands that make it possible to make waterproof connections. mains contacts: connect the mains power cable to the N and L contacts (100V~240V 50/60Hz). Since the complete unit is made of plastic, you won't find a ground connection. However you can connect an eventual ground wire to the dummy contact, next to the L contact. DMX input contacts: use the DMX in/out contacts when you want to control the unit by DMX or if you want to connect several units together in master/slave mode. How to set the DMX addresses: There are 2 ways to set the DMX-address of the units. Setting individual DMX-addresses per projector: Make sure the DMX cables of all units are connected. [. . . ] The installations should be inspected every year by a skilled person to be sure that safety is still optimal. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optics must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. [. . . ]