User manual JBSYSTEMS LIGHT LASER BURST III V 1.0

[. . . ] Surprising additional new dot and line effects create very realistic firework patterns, moving to the beat or at different user selectable speeds. The color of the beams changes all the time using laser blanking technology. Several working modes: o DMX 1CH for maximum ease of use o DMX 11CH for maximum control o Master/slave and standalone mode with 11 user modes for exciting, ever-changing laser effects Built-in microphone Static and music controlled strobe effects DMX-addressing with LED display Optional CA-8 controller for additional functions available Key actuated on/off switch and emergency switch (interlock) input for additional safety Perfect for use in bars, discotheques, clubs, mobile DJ, . The minimum distance between light-output and the illuminated surface must be more than 1 meter. [. . . ] The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. the parent document and cornerstone of laser safety standards ANSI Z136. 1 (2007) provides guidance for the safe use of lasers and laser systems by defining control measures for each of the four laser classes. Org Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!Use the keys to make sure only a skilled operator is able to switch the laser on. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. DMX OUTPUT: 3pin female XLR-connector used to connect the LASER BURST with the next unit in the DMX chain. Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. CONTROL PANEL: Used to select the different functions of the laser, see further to learn how to operate the unit. REMOTE CONTROLLER INPUT: Input for the CA-8 remote hand controller, see further for more information on this issue. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 10. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. INTERLOCK input: used to connect the optional emergency stop switch (see picture). For your own safety we strongly recommend to connect this optional switch!SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. Important: The installation must be carried out by qualified service personal only. [. . . ] When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]