User manual JBSYSTEMS LIGHT LASER BURST II V 1.0

[. . . ] Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. [. . . ] Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!Use the keys to make sure only a skilled operator is able to switch the laser on. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. DMX OUTPUT: 3pin female XLR-connector used to connect the LASER BURST with the next unit in the DMX chain. Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. CONTROL PANEL: Used to select the different functions of the laser, see further to learn how to operate the unit. REMOTE CONTROLLER INPUT: Input for the CA-8 remote hand controller, see further for more information on this issue. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 10. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. [. . . ]