User manual JBSYSTEMS LIGHT ILEAD CONTROLLER V1.1

[. . . ] No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. [. . . ] Stand alone: 2 extra easy controllers Incorporated for Master/Slave immediate pre-programmed light shows. program Mode: Activate Program mode by pressing Blackout/Stand Alone button. STAND ALONE: The connectors are used only in master/slave mode, using 5 pin XLR cable microphone jack of the first fixture, you will find that the remote control on the first unit will control all the other units for Stand by, Function and Mode. You can easily control pan, tilt, shutter, gobo, color, rotation, dimmer and focus functions on the lighting fixtures by pressing the relevant buttons showing on the control panel. With the use of joystick/ sliders, you will be able to quickly set the fixtures' Pan or Tilt position to make scenes. You can then save all these scenes step by step in a memory to create a chase (show). The controller allows you to program 24 chases with 485 programmable scenes maximum. PROGRAM MODE When power is turned on, the controller enters Programming mode automatically. The LED above this button lights off indicating Program mode in active. Hold on the BLACKOUT/STAND ALONE button for 3 seconds to enter StandAlone mode. Hold down the SCANNERS button and then press BLACKOUT/ STAND ALONE button. you will see the pan & tilt of all the fixtures in the chain stopping at the central position. The shutter & LED of the first fixture will open/ blink indicating the fixture is active, ready to be designated a new position ( the number in the chain ). If you have two chains in the venue, you can jog ( push ) joystick Left/Right to select chain 1 or chain 2, and jog joystick Up / Down to select next fixture or last fixture. BLACKOUT MODE Press the BLACKOUT/STAND ALONE button, the LED above this button lights up indicating Blackout in active. STAND ALONE MODE Hold on the BLACKOUT/STAND ALONE for 3 seconds, the LED above this button will blink indicating Stand-Alone mode in active. Press the BLACKOUT/STAND ALONE button again to return to the program mode. Different lights have different modes and different functions, which can be triggered by Stand Alone mode. Please refer to each lighting fixture's user manual for more details. SELECT THE FIXTURES YOU WANT TO CONTROL Press SCANNERS button You can choose one or more than one fixtures by pressing the 1~12 buttons When the buttons' LED ( 1 ~ 12 ) are lit, you can control the fixtures. To select fixture 13~24, press SCANNERS to next page, the lower LED will be on. SETTING SHUTTER Select the fixtures you want to control Press SHUTTER button Select a shutter value with the 1~12 buttons, or use the X-Fade/Value slider To select strobing speed 13~24, press SHUTTER again to next page the lower LED will be on. [. . . ] When the upper LED is on, then button 1 = memory 1, button 2 = memory 2. Etc, when the lower LED is on then button 1 = memory 13, button 2 = memory 14. Press the MEMORY button, choose the desired position (1 ~ 24) in which you want to insert a scene. Hold down PAGE and then press a button ( 1 ~ 24 ) where you want to copy the chase into it. [. . . ]