User manual JBSYSTEMS LIGHT HIGH Q10

[. . . ] 45-rpm Adaptor Slipmat Center Spindle Strobe Dots Power Button Start/Stop Button Target Light Headshell Speed Select Button Trim Control for changing the range of the Pitch Control Pitch Control Slider Tone arm Arm Rest Cueing Lever Anti-skating Knob Counterweight Position for preparing Cartridge Hinge for Dust Cover Remote Control This jack can be connected with an external switch to perform the Start/Stop operation. [. . . ] Connect the unit's output terminals to the PHONO jack of your mixer our amplifier (do not use a line input as this leads to insufficient signal level and non-linear frequency response). Connect the GND lead firmly to the GND screw on the mixer or amplifier. When this connection is not made, unnecessary hum or noise will occur. Set the tone arm lift to the up position and move the tone arm to the desired starting position. When there is not enough light, use the target light for spotting the exact starting position. Set the tone arm lift to the down position; the tone arml slowly lowers to the record. When the record has finished playing, move the tone arm lift to the up position and put the tone arm in rest position (down). When the strobe dots appear to flow to the right, the speed is slower that the rated speed. [. . . ] From time to time, the dust cover and turntable cabinet should be wiped with a soft, dry cloth. [. . . ]