User manual JBSYSTEMS LIGHT FX 1700 V 1.1

[. . . ] This product meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. This device has been designed to produce decorative effect lighting and is used in light show systems. High pressure pump for strong fog output Equipped with a diecast 1600W heater Interval timer remote control included Optional RC-1 wireless remote controller available Extremely reliable Before you start using this unit, please check if there's no transportation damage. [. . . ] Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. When the fuse is blown, first locate and solve the problem that caused the fuse to blow. When the problem is solved, simply push the button to reset the circuit breaker. MAINS CABLE: to be plugged in a mains wall socket with earth connection. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. The minimum distance between fogger output and objects must be more than 1 meter. NEVER hold your hands close to the fogger output, the fog is very hot and can cause serious burnings !To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Make sure that nobody can put their hands just in front of the output. Make sure to plug the fogger in a mains wall socket with earth connection Switch the fogger on and wait for about 8 minutes. Used with the supplied timer remote controller: Connect the special 5pin connector (1) to the remote input on the back of the fogger. Manual operation: When the fogger is ready for operation, the green LED on top of the "manual fogging" button (4) turns on. (after some time the green LED will turn off to indicate that the fogger is warming up again, during this time you can't produce any fog) Continuous operation: press button (5) the red LED will be lit while the fogger produces fog continuously. [. . . ] The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. Ce symbole représente la distance de recul minimum à respecter, c'est-à-dire, la distance minimum entre la machine à fumée et un objet. Utilisation avec la commande à distance sans fil (RC-1) : Raccordez le connecteur spécial à 5 broches (1) à l'entrée destinée à la commande à distance qui se trouve à l'arrière de l'appareil. Remarque : la distance maximum entre la commande à distance sans fil et la machine à brouillard est d'environ 25 mètres. [. . . ]