User manual JBSYSTEMS LIGHT EQ-215 V1.0

[. . . ] This appliance meets the requirements of the current European and national guidelines. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. [. . . ] The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. When the power switch is in OFF position, this unit is not completely disconnected from the mains!Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. [. . . ] Ground lift switch to separate the signal ground from the housing safely ground to avoid ground loops. Balanced outputs via 1/4" jacks; with unbalanced connections, do not connect the contact " - " 13. Balanced outputs via XLR jacks; with unbalanced connections, do not connect pin 3. [. . . ]