User manual JBSYSTEMS LIGHT DSP-4 V 1.0

[. . . ] To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. [. . . ] Return to the main menu: Press the MENU button to return to the main menu. DOWN BUTTON: Please refer to the menu structure to understand the different menus. These are the different possibilities: Browse the main menu: Press the MENU button together with the UP/DOWN buttons. In the ADDRess menu: Press the DOWN button to lower the DMX address of the selected channel. (press the button for a longer time to increase the speed) In the MODE menu: Press the DOWN button to put the selected channel in switch or dimmer mode. In the ALONE menu: Press the DOWN button to lower the dimmer value (0~100%) when the selected channel is in dimmer mode. When the selected channel is set to switch mode, you can turn the output on or off. UP BUTTON: Please refer to the menu structure to understand the different menus. These are the different possibilities: Browse the main menu: Press the MENU button together with the UP/DOWN buttons. in the ADDRess menu: Press the UP button to increase the DMX address of the selected channel. (press the button for a longer time to increase the speed) In the MODE menu: Press the UP button to put the selected channel in dimmer or switch mode. When the selected channel is set to switch mode, you can turn the output on or off. ENTER BUTTON: Please refer to the menu structure to understand the different menus. These are the different possibilities: In the main menu: Press the ENTER button to select the desired sub menu. DMX PRESENT LED: this LED indicates if the unit receives a DMX-signal on the DMX-input(n°2): LED is on: no DMX-signal detected on the input. CHANNEL OUTPUTS: Each channel output has its own output socket to connect any resistive and/or inductive projector(s) or small light effects. When the fuse is blown, first locate and solve the problem that caused the fuse to blow. When the problem is solved, simply push the button to reset the circuit breaker. ADDRESS SUBMENU: This menu is used to set the DMX address of the 4 output channels. Once you selected the desired channel, press the UP/DOWN buttons to set the address Press the MENU button to return to the main menu. MODE SUBMENU: This menu is used to set the working mode of the 4 output channels. DIM mode: use this mode when you connect lamps (projectors) to this output channel. [. . . ] IMPORTANT: since the ventilation holes are now located on the side facing the wall, you MUST use spacers to ensure at least 1cm between the unit and the wall surface! oVERHEAD RIGGING AND TRUSS MOUNTING: Important: Overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ]