User manual JBSYSTEMS LIGHT DMC.1000 V1.0

[. . . ] `t Hofveld 2C ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Please read these operating instructions carefully so you will know how to operate this product properly. After you have finished reading the instructions, put them in a safe place for future reference. [. . . ] TRACK indicator: shows the number of tracks available in your current selection. Standard lookup: (no Q-Dbase) the track numbers in the current folder (M) are shown. Q-Dbase lookup: the track numbers that correspond to your Q-Dbase pre-selection. FOLDER/SEARCH KEY indicator: the information depends on the lookup mode you selected. Starts flashing at the end of each track to alert the user to take action. During loop playback: shows the time remaining until the end of the loop. This visual aid helps you to see where and when the seamless loop starts again. PITCH DISPLAY: Shows the actual percentage of speed change, selected with the SPEED slider (30). The small red colored padlock is shown when the pitch lock function (Master Tempo) is active. A hard disk formatted in NTFS (mostly drives with big capacity) will NOT be recognized: such hard disk should be re-formatted in FAT32!(this can be done under Windows, we can't offer any support for this!) Note 2: the USB-slots on this player can each deliver 1A power to the connected hard disk. However we suggest using a hard disk with separate power supply for better reliability. use the supplied USB-cable to connect the USB-link connection (9) of player1 to the USB2-connection (8) rd of player2. (if you have a 3 player, connect players 2 and 3 in the same way) Use the SOURCE SELECT button (11) to select USB2 on the decks: the players will connect to hard disk. You can now play CDs and MP3 / WAV files from the connected hard disk. IMPORTANT: for good, stable performance only use a good quality USB-cable with a maximum length of 1meter!SETUP ­ MIDI CONTROLLER For each deck follow the instruction for "simple setup ­ 1 deck". Use the supplied USB-cable to connect the USB-link connection (9) of player1 to one of the USBconnections on your computer. Use the supplied USB-cable to connect the USB-link connection (9) of player2 to one of the USBconnections on your computer. Configure your DJ software so it can be used with the DMC1000: this configuration depends completely on the PC-program you will use. This part of the installation and the use of the PC software is not supported by Synq! [. . . ] DELETE THE "HOT CUE" BUTTONS: You can easily delete the contents of a HOT CUE button by pressing the DELETE CUE button (40), followed by the HOT CUE button you want to delete. You can also erase all four HOT CUE buttons together by pushing the DELETE CUE button (40) for more than 2 seconds. You will notice that all 4 HOT CUE buttons turn dark to indicate that the HOT CUE buttons are empty. USING THE "PERMANENT MEMORY": For security reasons the cue points and loops stored in the HOT CUE buttons are not automatically stored to the permanent memory. [. . . ]