User manual JBSYSTEMS LIGHT DE 600 V1.0

[. . . ] No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. [. . . ] (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not CAUTION remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. For more information on connections, please refer to the next chapter. Power (Power ON/OFF switch): Used to turn on the power of the unit, the associated blue led will be lit. Echo delay range: To make the delay control (4) more precise, it has 2 ranges. Peak led: monitors the signal levels, this led may only turn on from time to time. Echo Delay time: With this control you can set the length of the delay time. Together with the repeat time (5) you will be able to create the echo you desire. Echo repeat control: Used to control the feedback or number of echoes you want to create. Together with the delay time (4) you will be able to create the echo you desire. Echo level control: Used to control the level of the echo signal that will be mixed with the original. Use it to make the perfect balance between the original and the effect signal. [. . . ] Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. 1 is used with the effect section of a separate audio mixer, connect the effect send of the mixer to this input. The insert (16) and Mic1 inputs (17) can't be used at the same time!Both the insert (16) and Mic1 inputs (17) can't be used at the same time! [. . . ]