User manual JBSYSTEMS LIGHT DB-46 V 1.0

[. . . ] To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. [. . . ] The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. SLIDING MECHANISM: used to distribute your projectors evenly over the DB-46. END CAP: To install the bolts/nuts (needed to fix the projectors) and stand adapter you have to remove this end cap on one side of the unit: simply unscrew the 4 screws remove the cap put the nuts/bolts and/or stand adapter in the sliding rail put the cap back in place fix the 4 screws done!CHANNEL OUTPUTS: Each channel output has its own output socket to connect any resistive and/or inductive projector(s) or small light effects. Always replace the blown fuse with a fuse that has the same characteristics!IMPORTANT NOTE: It's very important to know that the maximum load for each channel is rated at 8A or 1850Watts. However the total load for all 4 channels may not exceed 20A or 4600Watts!POWER INPUT: mains input, equipped with a Neutrik Powercon , make sure the local voltage is 230Vac and the projectors (and/or light effects) are properly connected to the channel output sockets (1) before you connect an earthed mains cable to this input. When the fuse is blown, first locate and solve the problem that caused the fuse to blow. When the problem is solved, simply push the button to reset the circuit breaker. DMX OUTPUT: 3pin female XLR-connector used to connect the DB-46 with the next unit in the DMX chain. Two different stand adapters are included (also see number 9 for more information): 35mm adapter: to be used on stands with a standard 35mm top section. 28mm TV-Spigot: to be used on stands equipped with a TV-spigot adapter on top. DISPLAY: shows the information related to the selected function or working mode. The left digit shows the channel number, the 3 other digits show the channel status: In the address menu: channel address is shown, ranging from 001 to 512 In the mode menu: working mode is shown. [. . . ] It's important to know that the output settings are preserved when the unit is disconnected from the mains. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. ADDRESSMENU: This menu is used to set the DMX address of the 4 output channels. Once you selected the desired channel, press the UP/DOWN buttons to set the address Press the MENU button to return to the main menu. [. . . ]