User manual JBSYSTEMS LIGHT COLOR BURST V 1.0

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Operating instructions Color Burst Hanging bracket 2 Knobs to fasten the hanging bracket 2 Lamps CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. [. . . ] Apart from the lamp and mains fuse there are no user serviceable parts inside. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. Optical lenses + lamp compartment Mains cable Fuse holder Cooling fan Button used to control the music sensitivity Microphone Earth connection This symbol means: indoor use only. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Hold the lamp socket while pressing the new lamps gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. Don't use the effect in the presence of persons suffering from epilepsy. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. [. . . ]