User manual JBSYSTEMS LIGHT CLUB LASER 7 V 1.0

[. . . ] o AUTOMATIC mode: all internal programs will be shown automatically, no music needed o DMX mode: just set a DMX address and take full control of all internal programs!o ILDA mode: connect the laser to any PC with ILDA-compatible interface and use any professional laser software to create stunning laser shows, create logos, etc. Laser projections can be adapted to the size of the venue with X/Y image zoom controls Graphics can be mirrored for projections behind a transparent screen Blanking technology for nice separate beams Perfect for use in clubs, discotheques, publicity, exhibitions, and many more . . . Complies to EN/IEC 60825-1 for Laser Safety This symbol means: indoor use only. [. . . ] This is why the use of this laser for a Laser-Light-Show can be regarded as save. Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that BRITEQ cannot be made liable for damages caused by incorrect installations and unskilled operation! DESCRIPTION: 6. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging") 7. Use the keys to make sure only a skilled operator is able to switch the laser on. INTERLOCK input: used to connect the optional emergency stop switch (see picture). For your own safety we strongly recommend to connect this optional switch!Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and 255. DMX OUTPUT: 3pin female XLR-connector used to connect the laser with the next unit in the DMX chain. DMX INPUT: 3pin male XLR-connector used to connect universal DMX-cables. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of the music. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. X/Y SIZE CONTROL: use these controls to adapt the size of the projected graphics to the dimensions of the venue. X/Y MIRROR CONTROL: use these controls to mirror (reverse) the projections. This is for example useful when you project graphics from behind a transparent screen. ILDA INPUT: used to connect the laser to an ILDA certified interface of a computer, see further for more information. ILDA THROUGH: to link the ILDA signal to the next "Club laser 7" unit. 1. [. . . ] Some possible choices are: - PHOENIX software (www. bocatec. de) - PANGOLIN software (www. pangolin. com) - And many other, up to you and your finances to see what is best for your needs . . . MAINTENANCE Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. [. . . ]