User manual JBSYSTEMS LIGHT CD 570 V1.1

[. . . ] ⷠTo avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. ⷠChoose the place where you put your installation very carefully. ⷠThe player will work normally when installed on a surface with max. [. . . ] CUE button: Pressing the CUE button during play provides an immediate return to the position at which play was started. Playback is started immediately from the programmed cue point for as long as the CUE button is pressed. The CD player jumps back to the cue point as soon as the CUE button is released. Also with the unit in pause mode (Play/Pause LED blinks) the search and/or jog wheel is used to set a different start point. By pressing "PLAY/PAUSE" button then "CUE", you can confirm this new cue point. The CUE LED will light up since the cue button is pressed until the CD has returned to the position at which play was started. PLAY/PAUSE button: every time you press the PLAY/PAUSE button the CD player changes from play to pause or from pause to play. PITCH BEND buttons (+/-16%): The speed rises while the "+ button" is pressed and return to the original pitch when the button is released. PITCH button: This button is used to turn the Pitch function on and off. If you want to change the speed adjustment range (+/- 8%, +/- 12%, +/- 16%), press and hold PITCH button then press the PITCH BEND+ to select. OPEN/CLOSE button: press this button to open and close the disc tray in the front of the main unit. TIME Button: The TIME button switches between elapsed playing time, remaining time in a selection and total remaining time of the disc. SGL/CTN Button: with this button you can choose between "single track mode" and "continuous play". ⷠContinuous play: the complete CD will be played without interruption. (mostly used in pubs) · Single track: player stops at the end of each track and waits at the beginning of the next track. After programming the tracks will be played in the order you programmed. You can also use the relay function to make a preprogrammed sequence on the 2 decks. Follow the steps below for programming: · Press the PROGRAM button once, the led next to it turns on and the display shows "-- P-01 00". ⷠChoose the first track in your sequence and press the PROGRAM button. The first track is programmed, the display shows "-- P-02 01" · Choose the second track in your sequence and press the PROGRAM button. The second track is programmed, the display shows "-- P-03 02" · Continue these steps until you are finished. The first track in your sequence starts playing while the display shows"** P-01" The programmed sequence plays in an endless loop until you stop the program mode by pressing the PROGRAM button for about 2 seconds". [. . . ] ⷠTo stop the relay function, press the PROGRAM and SGL buttons again until the track information stops flashing. ⷠSTORING A CUE POINT: Put the player in pause and use the jog/shuttle wheel to search the exact location for the cue point. Once this location is found, press the PLAY/PAUSE button to set the new cue point. (the cue led flashes 2 times to indicate that the new cue point is set and the track starts playing from this new cue point) Once the cue point is programmed, just press the CUE button to recall it. [. . . ]