User manual JBSYSTEMS LIGHT CALYPSO V 1.0

[. . . ] If a foreign object enters the unit, immediately disconnect the mains power. Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. Don't cover any ventilation openings as this may result in overheating. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. [. . . ] Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. MENU button: used to select the different menu items DOWN button: to go back in the menu and to lower the values shown on the display. uP button: to go up in the menu and to increase the values shown on the display. MAIN MENU: To select any of the menu options, press the MENU button up to when the required one is shown on the display. once the required menu option is selected , press the ENTER button to select. To go back to the functions without any change press the MENU button or just wait 8 seconds. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Press the ENTER button, the current working mode starts blinking in the display Use the DOWN and UP buttons to select (master), (slave in sync with the master) or (2 light show ­ slave in anti-sync with the master). (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Remarks: when "SL 1" or "SL 2" is selected, some menu options are not available. DMX input DMX output ¼" Jack input for the optional CA-8 hand controller Internal microphone Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Slave LED: is lit when the unit is in slave mode Sound LED: blinks to the rhythm of the music while the unit is in audio mode DMX LED: is lit when the unit receives a DMX-signal Master LED: is lit when the unit is switched as master Show Mode Used to choose to select one of the preprogrammed shows when used in standalone or master/slave mode. This menu option is not available when the unit is set to slave mode ("S L 1 " or "S L 2 ")!Use DOWN and UP buttons to select one of the 11 preprogrammed shows ( (show 10) Once the right show blinks on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Blackout Mode Blackout mode: when no DMX-signal is detected, the unit goes in blackout. [. . . ] Read more about this option in the "How to setup" paragraph. mASTER has 11 built-in shows: You can select (show 0) to (show 10) directly in the menu of the master. SLAVES have 2 working options: These units are set to slave mode (slave-LED is constantly on). In order to create a great light show you can introduce contrast movements In the menu of the slave units you can go to option and select: o Normal slave: slave works in sync with the master. [. . . ]