User manual JBSYSTEMS LIGHT BT-575W V 1.0

[. . . ] Check the contents: Check that the carton contains the following items: BT-575W unit Operating instructions CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. The minimum distance between light-output and the illuminated surface must be more than 1 meters. [. . . ] Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in standalone or master/slave mode. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Once the mode is selected, press the ENTER button to setup ( or automatically return to the main functions without any change after 8 seconds. ) To go back to the functions without any change press the MENU button again. Show 3 mode - Fixture is placed on a podium, in front of the audience The spot is always projecting to the audience's direction; i. Tilt movement angle: 90° ( 60° above horizon; 30° below horizon. Tilt movement angle: 90° ( vertically, front 75°; back 15° ) Slave Mode Used to make the slave unit work in opposite to the master or to work in complete sync. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Blackout Mode Blackout mode: when no DMX-signal is detected, the unit goes in blackout and waits for the DMXsignal. No blackout mode: when no DMX-signal is detected, the unit automatically switches to standalone mode. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Show Mode Used to choose the Show mode when used in standalone or master/slave mode. Once the right mode shows on the display, press the ENTER button to save it. [. . . ] The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. The interior of the device should be cleaned annually using a vacuum cleaner or air-jet. The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. [. . . ]