User manual JBSYSTEMS LIGHT BT-250S V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. The minimum distance between light-output and the illuminated surface must be more than 1 meters. [. . . ] The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. never unscrew the screws of the rotating gobo as the ball bearing will be opened. Open the plastic top cover (4screws) Locate the gobo wheel and remove the fixation ring of the gobo you want to change with an appropriate tool. Press the fixation-ring together and insert it in the front of the gobo. Once the mode is selected, press the ENTER button to setup ( or automatically return to the main functions without any change after 8 seconds. ) To go back to the functions without any change press the MENU button again. REMOTE CONTROL INPUT: Used to connect a simple CA-8 hand controller while the unit is used in standalone or master/slave mode. SENSITIVITY: Used to adjust the sensitivity of the micro when the unit is used in standalone or master/slave mode. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Show Mode Used to choose the Show mode when used in standalone or master/slave mode. Once the right mode shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. [. . . ] By linking the units in master/slave connection, the first unit will control the other units to give an automatic, sound activated, synchronized light show. Its DMX input will have nothing plugged into it, and its master-LED will be constantly on and sound-LED will flash to the music. This function only works when the blackout mode in the menu of the master is set to OFF, otherwise nothing will happen! mASTER has 4 built-in shows: You can select (show 1) , (show 2) , (show 3) or (show 4) directly in the menu of the master. [. . . ]