User manual JBSYSTEMS LIGHT BEAT 6 USB V1.0

[. . . ] To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. [. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Except for microphones, headphone and master outputs, all connections are cinch. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. Both USB connections will be detected as a sound card on your computer. These connections are bidirectional (play/record music simultaneously) Accepts either a balanced microphone with an XLR connector or an unbalanced microphone with 1/4" mono jack. Use this control to adjust the level of the DJ microphone on the VU-meter at about 0dB. PANPOT CONTROL: Used to locate the sound from the DJ mic somewhere in the stereo field. A panpot control does the same for mono signals as a balance control does for stereo signals. TALKOVER: Use the switch to automatically mute the input channels 1 to 5 while you are talking through the DJ microphone. The more you turn the talkover level to the right, the more these channels are muted while talking through the DJ Mic(1). Pressing multiple Cue-buttons makes it possible to derive a mixed sound from the selected sources. CHANNEL VU METER: Each channel has its own LED VU-meter so you can adjust the gain level (11) very quickly. The audio risks to be distorted when the signal level comes in the red zone of the VU-meter. INPUT SOURCE SELECTOR: Used to select the correct input on each channel: Phono, line, USB, aux or mic. 3-BAND TONE CONTROLS: The frequency of each channel can be controlled separately over a range from -26dB to +12dB. BEAT COUNTER DISPLAY: Shows the number of beat per minute (BPM) of the music on the channel selected with the crossfader assign selector (16). To have a reliable result on the display the music must have a clear and steady beat. FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. CROSSFADER: With this VCA fader you can mix over between the channels you selected with the crossfader assign selectors (16). The crossfader only works when you move the selected channel faders (8) to the desired level! [. . . ] INPUT CHANNEL 4: used to connect a turntable and/or a line level audio signal. The input source selector (10) on the front determines which input will be active. If your turntable does not have a ground wire, you don't have to use this connector. INPUT CHANNEL 3: used to connect a turntable and/or a line level audio signal. [. . . ]