User manual JBSYSTEMS LIGHT BEAT 6 MK2 V1.2

[. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. [. . . ] Be sure to turn off the mixer before you make changes to the different connections. Accepts either a balanced microphone with an XLR connector or an unbalanced microphone with 1/4" mono jack. Use this control to adjust the level of the DJ microphone on the VU-meter at about 0dB. PANPOT CONTROL: Used to place the sound from the DJ micro somewhere in the stereo field. A panpot control does the same for mono signals as a balance control does for stereo signals. TALKOVER: Use the switch to automatically mute the input channels 1 to 5 while you are talking through the DJ microphone. The more you turn the talkover level to the right, the more these channels are muted while talking through the DJ Micro(1). Pressing multiple Cue-buttons makes it possible to derive a mixed sound from the selected sources. CHANNEL VU METER: Each channel has its own LED VU-meter so you can adjust the gain level (11) very quickly. The audio risks to be distorted when the signal level comes in the red zone of the VUmeter. INPUT SOURCE SELECTOR: Used to select the correct input on each channel: Phono, line, aux or mic. 3-BAND TONE CONTROLS: The frequency of each channel can be controlled separately over a range from -26dB to +12dB. BEAT COUNTER DISPLAY: Shows the number of beat per minute (BPM) of the music on the channel selected with the crossfader assign selector (17). To have a reliable result on the display the music must have a clear and steady beat. FADER START ON/OFF SWITCH: When you have a compatible CD-player connected to the fader control connectors, you can control its start/stop (re-cue) functions with the cross fader. BEAT OFFSET INDICATOR: This indicator has several colored LEDs which indicate if the beat on both beat counters are well synchronized. When both beat counters are completely out of sync, the red LEDs will be lit. You will have to adapt the speed of the connected audio sources so the beats will be nicely synchronized. Finally, when both beats are in perfect sync, the green led in the center turns on. CROSSFADER: With this fader you can mix over between the channels you selected with the crossfader assign selectors (17). The crossfader only works when you move the selected channel faders (8) to the desired level!CROSSFADER ASSIGN: Selects the input channels to be used with the crossfader (16) and beat counters (13). [. . . ] CROSSFADER MOVES TO THE RIGHT: CD-player connected to fader start connector 1 stops playing, returns to its previously programmed cue point and waits in pause. The other CD-player starts playing from its previously programmed cue point. CROSSFADER IN RIGHT POSITION: CD-player connected to fader start connector 2 is playing, the other CD-player is paused. CROSSFADER MOVES TO THE LEFT: CD-player connected to fader start connector 2 stops playing, returns to its previously programmed cue point and waits in pause. [. . . ]