User manual JBSYSTEMS LIGHT AM 50 V1.0

[. . . ] This appliance meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. Active studio monitor set equipped with 2x35Wrms amplifier Stylish black design: fits in any modern interior Solid wooden enclosure with black satin finish ® Perfect for recording studio, home DJ booth, PC-speaker, I-Pod , . [. . . ] If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. Switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. When the power switch is in OFF position, this unit is not completely disconnected from the mains!This appliance must be earthed to in order comply with safety regulations. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. [. . . ] INPUT GAIN: Used to set the output volume of the speakers BASS REFLEX OPENING: used to increase the bass response, never put objects in this opening!AUDIO OUTPUT: line level output (RCA connector), used to connect extra audio equipment. Optional RCA to 3, 5mm² stereo JACK ® cables are available from JB Systems (order code = MJC-1M5) SPEAKER OUTPUT: use the included speaker cable to connect the passive cabinet to the amplifier inside the active cabinet. [. . . ]