User manual JANE TRANSPORTER

[. . . ] It is only suitable for cars fitted with three anchoring point automatic belts, approved according to Regulation ECE-16 or other equivalent rules. Not all safety systems are exactly the same, so we advise that you check your TRANSPORTER in the car in which it is going to be fitted. [. . . ] Pressing the button on the lower part of the head area gives you two extra ventilation channels for the hottest seasons. The backrest of the new TRANSPORTER carrycot can be automatically adjusted using the adjustment device. There are two clear different positions (Fig 1b): AUTO Position: The backrest will always be in the lowest position, with the baby always lying down during the journey. Choosing where to install the safety seat Choosing the correct place for the safety seat in the car can reduce the risk of injury to your baby in the event of an accident. The safety carrycot should be installed on the back seat and in a sideways position. TRANSPORTER takes up two seats, you can choose between one side and the central seat, thereby allowing an adult to travel alongside, or completely centred. If you decide on the side central seat, position the TRANSPORTER so that the head part is as far away as possible from the door. In the reclining position, TRANSPORTER must be fitted cross-wise on the back seats. Decide on which seats after reading the section on "Choosing where to install the safety seat". 2a - Fasten the two straps you have chosen, the fasteners are on the abdominal part of the belt, this area is marked in light blue in the diagrams. 2b - If you have not lowered the backrest to the lying down position, the incorrect installation safety device will not allow you to insert the belt into the fastener. 2c - Open the fastener of the belt by turning the lock 2d - Insert the abdominal part of the belt into the fastener and close the fastener again. 2f - To take the TRANSPORTER seat out of the vehicle, open the fastener of the belt by turning the lock and take the seat belt off. Always remember to carry your baby with the safety harnesses correctly buckled. [. . . ] Undo the safety harness clasp and pass it through the slot in the mattress upholstery. Take the upholstery off the backrest and pass the shoulder straps through the slots. [. . . ]